AcidCrete.com Decorative Concrete Acid Stains, Dyes, Sealers, Cleaners, & Much More.

Quantity:

Crete Cure 25 (1 gallon jug)

Reg. Price:	~~$37.99~~
Sale Price:	$33.99
Save:	$4.00

Non-Yellowing 25% Solids Solvent Based Cure & Seal. Medium-High Gloss!

Details:

DESCRIPTION

Crete Cure 25 is a 25% solids, non-yellowing solvent based concrete cure & seal designed to cure and seal freshley placed concrete surfaces, as well as older concrete surfaces. Crete Cure 25 deeply enhances the natural color of a concrete surface, especially a stained surface.

WARNING

Combustible liquid (Flash point 108 degrees F). Keep away from open flame and heat. Do not smoke. Avoid direct contact. Skin and eye irritation may occur. Use in well-ventilated area. Inhalation of vapors may cause breathing difficulties. KEEP OUT OF REACH OF CHILDREN. Strongly recommended for exterior use only. First aid is as follows:

Eye contact: Move victim from exposure source. Flush eyes with water for 10-15 minutes.

Skin: Remove contaminated clothing. Wash with soap and water. If irritation persists seek medical attention.

Inhalation: Move victim to fresh air immediately. Contact physician if breathing is difficult.

APPLICATION INSTRUCTIONS:

SURFACE PREPARTAION: Concrete surface must be clean and free of all contaminants and water. Do not apply if rain is forecast within 24 hours. If moisture is present or if the surface is not clean and free of all contaminants, the sealer may have white spots and have premature delamination and failure. Substrate temperature must be no less than 40 degrees F and not exceed 80 degrees F. If applied outside these limits the sealer may not achieve adequate film formation and may have excessive air entrapment, bubbles, blushing or hazing.

MIXING: Stir well before using. Material may separate during long term storage.

APPLICATION: Apply using a 3/8" - 1/2" nap roller cover using long even uniform strokes at approximately 250-400 square feet per gallon depending on porosity and texture of substrate. A Chapin style solvent resistant sprayer may be used as well. Do not allow to Puddle! Thick or puddle areas may prevent the solvent from evaporating and may be susceptible to moisture intrusion which may cause milky white spots. Applying too thin may cause sealer to prematurely delaminate, flake or wear away. Allow sealer to dry for 24 hours for light traffic and at least 48 hours for heavy traffic. If applying two coats, wait approximately 4 - 6 hours between coats.

When using as a cure & seal to freshly placed concrete, only one coat should be applied at first. A second coat can be applied after 28 days. When using as a sealer (not to cure freshly placed concrete), a two coat application is recommended for concrete surfaces that have previously been unsealed. In rare occasions, a third coat may be necessary to provide a uniform finish to porous or uneven surfaces. For previously sealed concrete surfaces, a single coat should be sufficient in most cases.

PLEASE NOTE: It is always recommended to test the product in a small, inconspicuous area (on the same concrete substrate) for desired results prior to application. Coverage rates may vary for all coatings and substrates depending on porosity, density, texture etc. If applying by spray method, extended coverage rates may be achieved, but be aware that less material will be applied and inadequate film formation or performance expectations may be limited.

This Product meets or exceeds the following Cure & Seal Specifications:

ASTM C 1315, Type 1, Class A

ASTM C 309, Type 1, Class A & B

AASHTO M-148, Type 1, Class A & B

PLEASE NOTE: IT IS AGAINST VOC LAWS TO SHIP THIS PRODUCT TO THE FOLLOWING STATES: CALIFORNIA, OHIO, INDIANA, ILLINOIS, MAINE, VERMONT, NEW HAMPSHIRE, MARYLAND, RHODE ISLAND, MASSECHUSETTS, CONNECTICUT, NEW YORK, PENNSYLVANIA, NEW JERSEY, AND DELEWARE. ANY ORDER CONTAINING ANY ONE OF OUR CRETE SEAL LINE OF SEALERS TO BE SHIPPED TO ONE OF THE PRECEDING STATES WILL BE CANCELLED. WE RECOMMEND EITHER PURCHASING ONE OF OUR EPO-CRETE WB SEALERS OR PURCHASING A VOC COMPLIANT SEALER LOCALLY. WE APOLOGISE FOR ANY INCONVIENCE THIS MAY CAUSE. THANK-YOU...ACICRETE.COM

***Do not use solvent based and water based sealers together.

Customer Reviews
There are no reviews yet. create your own review