Crete Seal Kolours are non-yellowing, 100% pure acrylic opaque colored concrete sealers. Containing a high amount of solids content of the finest acrylic resin available, Crete Seal Kolours decorative concrete sealers provide a highly durable, decorative high gloss finish. Recommended for interior and exterior applications, Crete Seal Kolours will provide a long lasting colored seal and dust-proof at the same time. Crete Seal Kolours prove to be highly economical when compared to it's epoxy and urethane counterparts. Available in 14 brilliant but neutral colors, Crete Seal Kolours is the superior choice for the person who wants to not only seal, but add life to new or existing concrete surfaces in just one simple application. Do not make the mistake of purchasing paint, purchase Crete Seal Kolours for a superior, high gloss, protective coating.

SURFACE PREPARTAION: Concrete surface must be clean and free of all contaminants and water. Do not apply if rain is forecast within 24 hours. If moisture is present or if the surface is not clean and free of all contaminants, the coating may have white spots and have premature delamination and failure.

Substrate temperature must be no less than 40 degrees F and not exceed 80 degrees F. If applied outside these limits the sealer may not achieve adequate film formation and may have excessive air entrapment, bubbles, blushing or hazing.

MIXING: Mix well 1-2 minutes using a squirrel mixer prior to application. Material may separate during long term storage.

APPLICATION: Apply using a 3/8" - 1/2" nap roller cover using long even uniform strokes at approximately 200-350 square feet per gallon depending on porosity and texture of substrate. A Chapin style solvent resistant sprayer is not recommended for this coating due to high content of solids and possible color seperation. Do not allow to Puddle! Thick or puddle areas may prevent the solvent from evaporating and may be susceptible to moisture intrusion which may cause milky white spots. Applying too thin may cause sealer to prematurely delaminate, flake or wear away. Allow sealer to dry for 24 hours for light traffic and at least 48 hours for heavy traffic. If applying two coats, wait approximately 4 - 6 hours between coats. During application, it is recommended to have a helper with spiked shoes to back-roll the product to minimize bubbling caused by surface tension and/or quick roll applications.

PLEASE NOTE: It is always recommended to test the product in a small, inconspicuous area (on the same concrete substrate) for desired results prior to application. Coverage rates may vary for all coatings and substrates depending on porosity, density, texture etc. If applying by spray method, extended coverage rates may be achieved, but be aware that less material will be applied and inadequate film formation or performance expectations may be limited.